Installing The Tracking Plate On The Back Shell; Installing The Back Shell Onto The Mounting Hardware - Invacare Matrx MX1 Gebrauchsanweisung

3.5

Installing the Tracking Plate on the Back Shell

1. Disengage the cover (not shown) from the top and bottom of the
back shell A.
2. Remove the cushion and cover from the back shell.
3. Secure the tracking plate B to the back using the four screws C,
washers (not shown) and nuts (not shown). Tighten securely.
4. Secure the cushion and cover to the top of the back shell.
5. Secure the cushion and cover to the inside of the back shell.
6. Install the back shell.
C
B
Part No. 1176090
3.6
Hardware
1.
2.
3.
4.
5.
6.
7.
A
11
Installing the Back Shell onto the Mounting
If necessary, disengage the outer cover hook and loop strip at the
bottom rear of the back (not shown).
Loosen the two locking wedge washers A on each side of the
rigidizer bracket B.
Align the notched channel C in the bracket with the corresponding
raised area D on the mounting rail E.
Slide the mounting rail onto the rigidizer bracket.
Adjust the back cushion to the desired height along the channels in
the mounting rail.
Tighten the locking wedge washers on each side of the rigidizer
bracket to secure the back into position.
Adjust the back height. Refer to Adjusting the Back Height on
page 12.
2 & 6
TOP VIEW
A
A
B
3 MONO MOUNT
D
E
3-5
C
A
B
Invacare® Matrx® MX1