Specific Safety Advice; Installation; Motor Preparation; Preparing The Tube - SOMFY ilmo 50 M WT Installationsanleitung

ilmo 50 M WT

2.3 Specific safety advice

2.3.1 Roller shutter
- Check the strength of the roller shutter and its fittings.
The roller shutter must be fitted with:
• end stops screwed into the last slat, fixed (A) or remov-
able (B) stops incorporated in the runners or an end slat
acting as an end stop,
• bolts or rigid links (C).
- Check that the motor used is suitable for the size of roller
shutter, to avoid the risk of damaging the roller shutter
and/or the Somfy product.
For information about the compatibility of the motor
with the roller shutter and accessories, contact the
roller shutter manufacturer or Somfy.
2.3.2 Locks and rigid links
- After having affixed the roller shutter to the roller tube,
check that when the roller shutter is in the lower end limit
position, the rigid link/bolt is correctly positioned and that
the first slat is vertically between the runners (as per F). If
necessary, adjust the number of slates used to improve
the position of the bolt/rigid link when the roller shutter is
in the lower end limit position.
- Always refer to the manufacturer's size and weight charts
and fitting recommendations for the rigid links or locks to
select those suited to the roller shutter used.
Use at least 2 bolts or 2 rigid links to attach the roller
shutter to the roller tube.

3. Installation

3.1 Motor preparation

1) Fit the crown (A) and the drive wheel (B) to the motor.
2) Measure the length (L1) between the base of the motor
head and the end of the drive wheel.

3.2 Preparing the tube

1) Cut the roller tube to the required length.
2) Deburr the roller tube and remove the swarf.
3) For smooth roller tubes, cut a notch with the following
measurements:
- e = 4 mm
- h = 28 mm
4
F
F
1
2
1
3
Copyright © 2011 Somfy SAS. All rights reserved.
C
A
B
B
A
L1 = ...
L1
2
Ø > 47
h
e