Restoring The Original Configuration; Technical Specifications - SOMFY ilmo 50 M WT Installationsanleitung

6.2 Restoring the original configuration

6.2.1 Using the control point connected to the roller shutter
Follow each of the 4 steps in the procedure carefully to correctly restore the original
configuration.
1) Place the roller shutter in the mid-height position.
2) Repeat the next step 3 times in succession
- Press the Up button until the roller shutter moves.
Release the button immediately.
3) Repeat the next step twice in succession
- Press the Down button until the roller shutter
moves. Release the button immediately.
4) Press the Down button again until the roller shutter
makes 2 successive movements in the same direction.
► The motor has been reinitialised with the original
configuration. Repeat the commissioning process.
6.2.2 Using the wired electronic motor setting tool
- Press the Up and Down buttons on the setting tool at the
same time until the roller shutter makes an initial up and
down movement followed by a second one.
► The motor has been restored with the original
configuration. Repeat the commissioning process.

7. Technical specifications

Power supply
Operating temperature
Index protection rating
Operating category
Copyright © 2011 Somfy SAS. All rights reserved.
1 2
3 4
x 2
7s
230V/50 Hz ~
- 20°C to + 70°C
IP 44
I
ilmo 50 M WT
x 3
7