Storch Spider Gebrauchsanleitung Seite 55

DO NOT OPERATE THE SANDER UNTIL YOU HAVE
READ THE ENTIRE INSTRUCTION MANUAL.
Attaching the Sanding Media
1. Unplug the device.
2. Remove the worn sanding disc from the hook-and-
loop sanding pad, which remains at its position.
3. Carefully centre-align the new sanding disc and
press it down. It will be held securely by the hook-
and-loop sanding pad.
Replacing the Hook-and-Loop Sanding Pad
The hook-and-loop sanding pad must be absolutely even
in order to achieve good sanding results. Deformed or
damaged pads will do an uneven sanding job. Always
replace damaged pads. The pad has a hook-and-loop
film on both sides; to replace the hook-and-loop film,
remove the entire pad and replace it with a new hook-
and-loop sanding pad.
Replacing the Brush Collar at the Edge of the San-
ding Head
The brush collar at the edge of the sanding pad ser-
ves two purposes: it keeps the sanding disc properly
aligned with the work surface, thereby preventing the
formation of grooves, and it supports the dust suction
with the vacuum cleaner. This brush collar will wear
with continuous use. When the brush collar is worn,
the entire sanding pad housing must be replaced to
ensure effective dust suction and stabilisation of the
sanding pad.
To replace the sanding pad housing, contact
an authorised STORCH customer service
centre.
NOTE: Only use hook-and-loop sanding discs
that are suitable for the "Spider" wall and
ceiling sander.
Attaching the Suction Hose with Bayonet Connec-
tor
1. Unplug the sander.
2. Connect the bayonet connector of the suction
hose to the connection port under the sander's
handle. Once the tangs of the bayonet connector
have reached the end of the slots, hold the swivel
connector and turn the bayonet connector of the
hose to the right.
3. To disassemble, follow the assembly instructions
in reverse order.
Vacuum Cleaner
Use a suitable vacuum cleaner for sanding tasks.
WARNING: Failure to use the device
without a vacuum cleaner will increase
the level of airborne dust at the work-
place. Prolonged exposure to such dust
may damage your respiratory system.
Always wear a suitable and approved dust mask while
doing sanding work.
55