Cleaning And Storing The Device And Cuff; Specifications - Beurer BM 58 Gebrauchsanweisung

10. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy
objects on the device and cuff. Remove the batteries. The
cuff line should not be bent sharply.

11. Specifications

Model no. BM 58
Measurement Oscillometric, non-invasive blood pres-
method sure measurement on the upper arm
Measurement Cuff pressure 0 – 300 mmHg,
range systolic 60 – 260 mmHg,
diastolic 40 –199 mmHg,
Pulse 40 –180 beats/minute
Display accuracy Systolic ± 3 mmHg, diastolic ± 3 mmHg,
pulse ± 5 % of the value shown
Measurement Max. permissible standard deviation
inaccuracy according to clinical testing:
systolic 8 mmHg /diastolic 8 mmHg
Memory 2 x 60 memory spaces
Dimensions L 100 mm x W 150 mm x H 58 mm
Weight Approx. 508 g
(without batteries, with cuff)
Cuff size 22 to 30 cm
Permissible oper- +5 °C to +40 °C, ≤ 90 % relative air
ating conditions humidity (non-condensing)
Permissible -20 °C to +55 °C, ≤ 95 % relative air
storage conditions humidity, 800 –1050 hPa ambient pres-
sure
Power supply
4 x 1,5 V
Battery life For approx. 500 measurements,
depending on the blood pressure level
and/or pump pressure
Classification Internal supply, IPX0, no AP or APG,
continuous operation, type BF applied
part
The serial number is located on the device or in the battery
compartment.
Technical information is subject to change without notifica-
tion to allow for updates.
• This unit is in line with European Standard EN 60601-
1-2 (In accordance with CISPR 11, IEC 61000-4-2, IEC
33
AA batteries