Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.3.2 Operation with Digital
Important:
All of the Märklin central units with
the Motorola transmission format can
be used to run this locomotive. The
full range of functions is only available
with the 6021 Control Unit 6021.
Functions f1 through f4 cannot be
activated if you are using the earlier
Central Unit 6020 or a similar version.
The indicator for direction of travel is
also not present on these units.
The coding switches on the back of
the Control Unit 6021 must be set as
follows for trouble free operation:
Switch:
1
2
3
Setting:
on
on
on
Operating the locomotive with the
Control Unit 6021:
Entering the locomotive address.
Turning the speed control knob to
the right to the stop increases the
locomotive's speed. Turning the
speed control knob to the left to the
"0" setting decreases the locomoti-
ve's speed.
Important:
There will be a delay in the locomoti-
ve's reaction to each change in
speed, depending on how you have
set the acceleration/braking delay.
Turning the speed control knob to
the left past the "0" setting: Reverses
4
the locomotive's direction of travel.
off
Important:
On the Control Unit 6021 two arrows
to the right of the address display
indicate the direction of travel for the
locomotive.
Arrow pointing up:
Locomotive runs forward.
Arrow pointing down:
Locomotive runs in reverse.
Pressing the "function" button:
Turns the headlights on.
Pressing the "off" button:
Turns the headlights off.
Pressing button "f2":
Turns the sound effects circuit on
(locomotive operating sounds).
Pressing button "f2" again turns the
sound effects off.
Pressing button "f3":
Turns the sound of a horn on. Now
quickly turn this function off by
pressing button "f3" again! Otherwise,
it can lead to malfunctions.
2
Operation
Starting status:
Indicator LED above button "f4" is off:
Pressing button "f4" does the following:
Minimizes the acceleration and braking
delay that has been set.
Starting status:
Indicator LED above button "f4" is on:
Pressing button "f4" does the following:
Turns the acceleration and braking
delay that has been set on the digital
electronic circuit back on.
2.3.3 Running the Locomotive
with Delta
To operate the locomotive with Märklin
Delta you use the Delta Mobil to sel-
ect the address, that has been set on
the former. The locomotive will run
forward when you turn the speed
control knob to the right of the center
position. Turning the speed control
19
Werbung
Inhaltsverzeichnis
