Care And Maintenance - PeakTech 2025 Bedienungsanleitung

9. Care and Maintenance

9.1. Installing the battery
Your meter requires a 2 pcs. 1,5 V AAA (UM-4) batteries for power. The
battery symbol appears when the battery voltage drops to the
certain limits. For proper operation, replace the battery as soon as
possible. Continued use with a low battery will lead to abnormal
readings.
Warning!
To avoid electric shock, disconnect both test leads from equipment
before you remove or install the batteries.
Follow these steps to install the batteries:
1. Turn off the power and disconnect all test leads.
2. Remove the screw to open the battery cover.
3. Remove the batteries and install new 1,5 V AAA (UM-4) batteries.
4. Replace the battery cover and secure it with the screw.
WARNING!
Do not operate the meter until you replace the battery and close the
battery compartment cover.
Notes:
Never leave a weak or dead battery in your meter. Even a leakproof
battery can leak damaging chemicals. When you are not going to use
your meter for a week or more, remove the battery.
Batteries, which are used up dispose duly. Used up batteries are
hazardous and must be given in the for this being supposed collective
container.
-49-