Commissioning; Function Check; Switching On The Device; Display And Operating Elements - Endress+Hauser iTEMP HART TMT142 Bedienungsanleitung

Commissioning

Pos. Function
no.
4 Measured value display
(0.81" / 20.5 mm character size)
5 Status and information display
6 Display "Communication"
7 Display "Configuration locked"
4.3.2 Local operation, setup of the hardware
Fig. 8: Hardware setup using jumpers J1, J2 and J3
ESD – Electrostatic discharge
Protect the terminals from electrostatic discharge. Failure to observe this may result in
destruction of parts of the electronics.
Jumpers J1, J2 and J3 for the hardware setup can be found on the electronics module. In order
to set the jumper, open the device cover and if applicable pull off the display.
28
Description
Measured value display. If a warning is present this
display alternates between the measured value and the
warning code. In the event of an error, the error code
is dispalyed instead of the measured value.
Display of which value is being indicated on the
display. On PV a customer specific text can be entered.
On warning, the display shows the warning code as
well as "WARN". On faults the display shows
"ALARM".
The communication icon appears on read or write
access using the HART
If the software or hardware setup/configuration is
locked, the "Configuration locked" icon appears.
TMT142 HART®
®
protocol.
T09-TMT162ZZ-19-00-00-xx-001
Endress+Hauser