Setting The Volume; Outgoing Messages - switel DET0872 Bedienungsanleitung

Operating the Answering Machine Via the Base Station

Setting the volume

If the volume of the answering machine is too high or low when playing back messages or listen-
ing−in to incoming calls, it can be adjusted to one of 10 levels.
: or ;
Playing the day and time
The current weekday and time are announced after pressing the s button.

Outgoing messages

Selecting the answering mode
The answering machine is provided with two, pre−recorded outgoing messages. A distinction is
made between outgoing message with message recording (OGM 1) and outgoing message only
(OGM 2). If no other outgoing message is recorded, the pre−recorded outgoing message is
played automatically. When the answering machine memory is full, it automatically reverts to the
outgoing message only (OGM 2) message explaining to the caller that messages cannot be left.
Proceed as follows to change the answering mode:
2 sec @
w
or
v
The outgoing message currently set is then played back.
Recording outgoing messages
Your own outgoing message must be minimally 5 seconds and maximally 1:30 minutes long.
Firstly, select the outgoing message type you want to replace (Page 58). The respective, pre−
recorded outgoing message is replaced by the one you record. The pre−recorded outgoing mes-
sages can be restored simply by deleting your own outgoing message.
2 sec @
w or v
{ì} ð
The new outgoing message is played back.
Playing the current outgoing message
@
s
60
Set the volume
Activate the outgoing message mode.
Selects OGM 1 (with recording)
Selects OGM 2 (without recording)
Activate the outgoing message mode.
While the outgoing message is playing, press and hold the
Rewind button (to change OGM 1) or Forward button (to
change OGM 2).
Press the button and speak after the acoustic signal. To end
recording, simply release the w or v button.
Play the outgoing message
Stop playback