Commissioning; Safety Information; Check Contents Of Pack; Connecting The Telephone Receiver - Switel T19 Bedienungsanleitung

3

Commissioning

3.1

Safety information

Note! Before commissioning, it is essential that you read the general information at the begin
ning of this manual.
3.2

Check contents of pack

The following items are supplied:
one telephone base
one telephone connection cable
one desk adapter
3.3

Connecting the telephone receiver

After unpacking your telephone, you must first connect the telephone receiver to the base unit.
First take the short end of the spiral cable and plug it into the socket at the bottom of the receiver.
Turn the telephone over and plug the long end of the spiral cable into the socket marked
HANDSET. Feed the cable through the cable channel to the outside.
3.4

Connecting the telephone

Connect the telephone cable supplied to the telephone socket and the telephone jack LINE on
the underside of the telephone. Then feed the cable out of the telephone housing either upwards
or downwards through the cable guide. Clip the cable firmly in the cable channel. The telephone
works using the tone dialling system.
3.5

Fitting the desk support

If you intend to use your telephone on a desk, then the desk support supplied must be fitted. To
do this, turn the telephone over. Now insert the two upper hooks into the openings provided and
push the desk support firmly home.
If you ever need to remove the support, press gently on the middle clips on the upper edge and
then pull the desk support off.
In the receiver rest there is a small hanging device, which is used when the telephone is wall
mounted. This hanging device is not required when the telephone is used on a desk, as it
impedes the lifting of the receiver. Using a small screwdriver, turn this hanging device until the
screw is completely flush and its upper end does not protrude at all.
3.6

Wall mounting

Your telephone is also suitable for wall mounting. Use two screws for fixing. Drill two holes
vertically, 67 mm apart, and leave the screws protruding from the wall by 5 mm. Now place the
telephone without the desk support over the screws and push it slightly downwards.
There is a small hanging device in the receiver rest to prevent the receiver from falling when it is
placed on the rest with the telephone mounted on the wall. Using a small screwdriver, turn this
hanging device until a small hook appears at the upper end.
If you are using the telephone fitted to the wall, you can hang the receiver on the telephone
without hanging up. You will find a small hook for this purpose at the upper end of the receiver
rest.
- Commissioning -
one telephone receiver
one spiral cable
one Operating Manual
37