Transmitter unit
1
Status LED
2
Switch unit on/off
3
Paging button
4
Microphone (rear side)
5
Socket for power adapter plug
4 Starting Up
Inserting the batteries
1.
Open the battery compartment on the receiver unit.
2.
Insert 2 AAA batteries (contained with the material supplied) in
the battery compartment. Pay attention to correct polarity!
3.
Close the battery compartment.
Charging the batteries
Connect the power adapter plug to the receiver unit and a properly
installed mains power outlet. Charging of the batteries begins
automatically.
S
When the status LED flashes red, the batteries must be
charged.
S
When the batteries are fully charged, the status LED goes
out.
S
The status LED lights up red when the device is switched
on during the charging process.
1
2
3
5
4
31