Technical Specifications - Fujitsu KVM s3-1621 Bedienungsanleitung

Appendices
• Always install jacks to prevent dust and other contaminants from settling on the
contacts. The contacts of the jack should face up on the flush mounted plates, or
left, right, or down on surface mount boxes.
• Always leave extra slack in the cables, neatly coiled in the ceiling or nearest
concealed location. Leave at least five feet at the work outlet side and 10 feet at the
patch panel side.
• Choose either 568A or 568B wiring standard before beginning. Wire all jacks and
patch panels for the same wiring scheme. Do not mix 568A and 568B wiring in the
same installation.
• Always follow all local and national fire and building codes. Be sure to firestop all
cables that penetrate a firewall. Use plenum rated cable where it is required.
5.4

Technical specifications

Target Server Ports
Number
Types
Connectors
Sync Types
Plug and Play
Video Resolution
Supported Cabling
Serial Port
Number
Cable type
Connector
Network Connection
Number
Type
Connector
Table 2: KVM s3-1621 appliance product specifications
50
16
ARI
RJ-45
Separate horizontal and vertical
DDC2B
640 x 480 @ 60 Hz (Local Port and Remote Port Minimum)
800 x 600 @ 75 Hz
960 x 700 @ 75 Hz
1024 x 768 @ 75 Hz
1280 x 1024 @ 75 Hz (Remote Port Maximum using a
KVM-IA)
4-pair UTP Cat 5 or Cat 6, 10 meters maximum length
1
Serial RS-232
DB9 female
1
Ethernet: IEEE 802.3 2002 Edition - 10BASE-T, 100BASE-
T1000BASE-T
RJ-45
590-591-609D