Setting The Keyboard Country Code - Fujitsu KVM s3-1621 Bedienungsanleitung

Basic operations
3.9.6

Setting the keyboard country code

By default, the KVM s3-1621 appliance sends the US keyboard country code to USB
cables attached to target devices, and the code is applied to the target devices when
they are turned on or rebooted. Codes are then stored in the
KVM-IA. Using a keyboard code that supports a language different from that of the
KVM s3-1621 appliance firmware will cause incorrect keyboard mapping.
If multiple keyboards are connected to the local port, they must be of the same type (PC
or Mac) and of the same language.
Issues might arise when you use the US keyboard country code with a keyboard of
another country. For example, the Z key on a US keyboard is in the same location as
the Y key on a German keyboard.
You can use the Keyboard window to send a different keyboard country code than the
default US setting.
Figure 16: Keyboard window
Press Print Screen to start the OSCAR interface. The Main window opens.
Click Setup - Keyboard. The Keyboard window opens.
Select the country code for the keyboard, and click OK. Confirm the change in the
Keyboard Warning window.
Click OK to save the change, or click X or press Escape to exit without saving the
change.
28
590-591-609D