Scanning The Switching System; Adding Target Devices To The Scan List - Fujitsu KVM s3-1621 Bedienungsanleitung

3.12

Scanning the switching system

In scan mode, the KVM s3-1621 appliance automatically scan from port to port (target
device to target device). Use scan mode to monitor the activity of up to 16 target
devices, and to specify which target devices to scan and the number of seconds that
each target device will be visible. The scanning order is determined by placement of the
target device in the list, which is always shown in scanning order. You can choose to list
the target devices by name, EID number, or port number by clicking the corresponding
button.
3.12.1

Adding target devices to the scan list

Click Setup - Scan. The Scan window opens.
Figure 23: Scan window
The window contains a listing of all target devices that are attached to the KVM s3-
1621 appliance. To select target devices to be scanned, complete one of the
following steps:
• Select the check box next to the target devices that you want to scan.
-or-
• Double-click on a target device name or port.
-or-
• Press Alt and the EID number of the target device that you want to scan. You
can select up to 16 target devices from the list.
In the Time field, type the number of seconds (from 3 to 255) of time before the
scan moves to the next target device in the sequence.
Click OK.
590-591-609D
Scanning the switching system
37