Configuring Network Speed Settings - Fujitsu KVM s3-1621 Bedienungsanleitung

Computer terminal operations
3: IPv4 DHCP (Dynamic Host Configuration Protocol), 4: IPv6 Static, or 5: IPv6
DHCPv6.
A static IP address can be used to provide a user-defined IP address, netmask, and
default gateway for the KVM s3-1621 appliance. Use a static IP address for ease of
configuration. DHCP is a protocol that automates the configuration of TCP/IP-
enabled computers. When DHCP is selected, the IP Address, Netmask, and
Default Gateway settings are automatically assigned to the KVM s3-1621 appliance
and cannot be modified by a user. If you are using the DHCP option, configure the
DHCP target device to provide an IP address to the KVM s3-1621 appliance and
then skip step 5.
Select the remaining options from the Network configuration menu to finish the
configuration of the KVM s3-1621 appliance with an IP address, netmask,
default gateway, and ping response.
Type 0 (zero) and press Enter to return to the Console Main menu. The KVM s3-
1621 appliance will then reboot.
4.1.2

Configuring network speed settings

When changing network speed and/or network duplex settings on a FTS Digital KVM
switch, the following rules must be considered:
RULE: The settings of the FTS Digital KVM switch and the Network Switch port to which
it is connected must be set to the EXACT same settings.
Examples:
• If the FTS Digital KVM switch is set to Auto-Negotiate, then the Network Switch
MUST be set to Auto-Negotiate both SPEED and DUPLEX.
• If the FTS Digital KVM switch is set to 100MB - FULL duplex, then the Network
Switch must be set to 100MB - FULL duplex.
• If the FTS Digital KVM switch is set to 10MB - HALF duplex, then the Network
Switch must be set to 10MB - HALF duplex.
RULE: If the FTS Digital KVM switch has been in use within the past hour and you have
changed the network settings, ARP tables in the network may need refreshing/flushing
before a new connection can be established with the FTS Digital KVM switch.
To refresh the ARP tables, do one of the following:
Wait about 10 minutes or so for the ARP tables to rebuild automatically.
-OR-
Clear the ARP table entry in a FTS Client Viewer workstation and Ping the appli-
ance at its IP address.
commands:
ARP -d 1.2.3.4 (Where 1.2.3.4 is the IP address of the FTS Digital
a.
KVM switch.)
b. PING 1.2.3.4 (Where 1.2.3.4 is the IP address of the FTS Digital KVM switch. If
the PING is successful, the FTS Digital KVM switch is ready for operation.)
42
This can be done from a DOS window with following
590-591-609D