Programmes; Options; Deactivating The Acoustic Signals - Progress PVS1535 Benutzerhandbuch

PROGRAMMES

1)
Programme
2)
3)
4)
5)
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase, the
temperature stays at 70 °C for 10 to 14 minutes.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery
with normal soil. (This is the standard programme for test institutes).
5) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad
odours to come out from the appliance.
Do not use detergent with this programme.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

OPTIONS

Acoustic signals
The acoustic signals operate in these con-
ditions:
• When the programme is completed.
• A malfunction occurs to the appliance.
Factory setting: on.
You can deactivate the acoustic sig-
nals.

Deactivating the acoustic signals

1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
Degree of soil
Type of load
Heavy soil Prewash
Crockery, cutlery, Wash 70 °C
pots and pans Rinses
Dry
Normal soil Prewash
Crockery and cut- Wash 65 °C
lery Rinses
Dry
Fresh soil Wash 65 °C
Crockery and cut- Rinse
lery
Normal soil Prewash
Crockery and cut- Wash 50 °C
lery Rinses
Dry
All Prewash
Programme Duration
phases
110 - 120
100 - 110
30
120 - 130
11
3. Press and hold the programme button
until the programme indicator (A) flashes
and the programme indicator (B) comes
on.
4. Press immediately the programme but-
ton.
• The programme indicator (A) comes
on with a fixed light.
• The programme indicator (B) starts to
flash.
5. Wait until the programme indicator (A)
goes off and the end indicator comes
on (the programme indicator (B) contin-
ues to flash).
• The acoustic signals are on.
Energy
(min) (kWh)
1.5 - 1.7
1.4 - 1.5
0.8
0.8 - 0.9
0.1
progress 17
Water
(l)
18 - 20
18 - 20
8
12 - 13
5