Erstellt
von
Name:
Holger Seebode
Datum:
9.7.1998
3.4 HART-Command 3 : Read all dynamic Variables and Current
Request
none
Data Bytes
Response
#0..#3
Data Bytes
#4
#5..#8
#9
#10..#13
#14
#15..#18
#19
#20..#23
Response
0
Codes
5
Bemerkung
3.5 HART-Command 6 : Write Polling Address
Request
#0 Polling Address of Device
Data Bytes
Response
#0 Polling Address of Device
Data Bytes
Response
0
Codes
2
5
3.6 HART-Command 11 : Read Unique Identifier Associated With Tag
Request
#0..#5 Tag, Packed ASCII
Data Bytes
Response
#0
Data Bytes
#1
#2
#3
#4
#5
#6
#7
#8
HART-Protokoll
Gerät: COPA/MAG-XE, 50XE4000
Software: HART-Software
Kennung: D699B180 X.10
Projektnummer:
Analog Output Current mA, IEEE 754
Primary Variable Unit Code (Table 2)
Primary Variable, IEEE 754
Secondary Variable Unit Code (Table 2)
Secondary Variable, IEEE 754
Tertiary Variable Unit Code (Table 2)
Tertiary Variable, IEEE 754
4th Variable Unit Code (Table 2)
4th Variable, IEEE 754
No Command Specific Error
Incorrect Byte Count
Primary Variable
=
Durchfluß, Einheit siehe unsigned char-Slot 3
Secondary Variable =
Zähler >V, Einheit siehe unsigned char-Slot 4
Tertiary Variable
=
Zähler <R, Einheit siehe unsigned char-Slot 4
Fourth Variable
=
Durchfluß, Einheit siehe unsigned char-Slot 3
No Command Specific Error
Invalid Selection
Incorrect Byte Count
Device Type Code for Expansion
Manufacturer Identification Code
Manufacturer Device Type
Number of Request Preambles
Revision Level of Universal Command
Revision Level of Transmitter Document
Software Revision Level
Hardware Revision Level
Flags, none defined at this time
Revision:
0
Name:
Holger Seebode
Datum:
9.7.1998
Revision
Revision
Revision
= 254
= 18 = F&P
= 8 = XE4000
= 8
= 5
= 0
= 1
= 0 oder 1
= 0
3-2