Installation And Start-Up - Cebora SYNSTAR 270 T Bedienungsanleitung

A – DISPLAY SCREEN.
This displays both the welding parameters and all the
welding functions.
B - KNOB
Selects and adjusts both the welding functions and
parameters.
C – CENTRALIZED COUPLING
To which the welding torch must be connected.
D – EARTH LEAD OR SOCKET
Where you must connect the earth cable connector.
H – CONNECTOR
This is where the control cable of the Push Pull welding
torch Art. 2003 or Art. 2010 is connected.
4 CONTROLS LOCATED ON REAR PANEL.
E
F
G
E – GAS PIPE CONNECTION.
F – SWITCH.
Starts and stops the machine
G – MAINS CABLE
I - FUSE HOLDER.
L – SOCKET.
Socket which receives the power cord from the cooling
unit Art.1681 (optional).
M – PRESSURE SWITCH CONNECTOR.
Connector which receives the cable from the pressure
switch Art.1681 (optional).

5 INSTALLATION AND START-UP

Position the welding machine so as to allow the free circulation
of air inside and, as much as possible, prevent metal or other
dusts from penetrating.
• The machine must be installed by professional personnel.
• All the connections must be performed in compliance
with applicable standards (IEC/CEI EN 60974-9) and with
accident-prevention laws.
• Make sure the power supply voltage corresponds to the
welding machine rating.
• The protection fuses must be sized according to the details
shown on the technical data plate.
I
• P osition the cylinder on the support and fix it with the 2
straps; ensure that the straps are secured tightly to the
cylinder to prevent dangerous tilting.
M
• Connect the gas hose to the outlet of the pressure regulator.
• Open the side door.
• Connect the power cord to the socket D and through
L
the clamp to the workpiece.
• Connect the earth lead clamp D to the piece to be welded.
• Fit the wire coil on the support inside the compartment.
The coil must be fitted so that the wire unwinds in an
anticlockwise direction.
• Make sure the drive roller is correctly positioned according
to the diameter and type of wire used.
• Cut the welding wire with a well-sharpened tool, keeping
it between your fingers so that it cannot unwind, insert it
inside the pipe exiting from the gear motor and, with the aid
of a finger, insert it inside the steel tube until it comes out of
the adapter.
• Fit the welding torch.
After fitting the reel and torch, switch on the machine, select
the suitable synergic curve, following the instructions given
in the service functions (PROCESS PARAMS) paragraph.
Remove the gas nozzle and unscrew the current nozzle
of the torch. Press the torch button until the wire comes
out. BE CAREFUL to keep your face away from the end
lance while the wire is coming out, screw up the current
nozzle and fit the gas nozzle.
11