Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Prior to installation work
1. Check the strength of the installation location.
1. The ceiling unit for vertical hanging weighs approx. 15 kg (33.1 lbs) and that for inclined hanging
(at an angle of 5, 10, 15, or 20 degrees) weighs approx. 37 kg (81.6 lbs).
For the mass of the display to be installed on the ceiling unit, refer to the instruction manual for the
Plasma Display.
2. When installing the ceiling unit, always support its weight with four or more wire ropes etc. and
install two or more other wire ropes so as to prevent the unit from falling down onto personnel in
the site even if it should come off. Besides, install a swing stop according to the circumstance.
Caution
● Before installing the ceiling unit, check the installation location of the ceiling for strength. If the installation
location is not strong enough, reinforce the ceiling adequately.
2. Prepare the Plasma Display.
2
3
4
3
4
16
Caution
● Because the display is heavy, handle it carefully by the use of lifting
equipment (machine).
● The display has the operation part on its right side face. Do not bump the
1
operation part against any things located around, during installation.
1. Place the hook of lifting equipment in the display's center eyebolt,
lift up the display, and put it on soft stuff such as a blanket.
(The display should be kept in an upright position.)
2. Unscrew the left and right eyebolts on the top of the display.
3. Remove eyebolt caps (in 2 places on each side) on the back of the
display. Fit the just-removed eyebolt caps in the holes that eyebolts
were removed from.
4. Unscrew the stand hooks with the Allen wrench supplied with the
display.
※ Removed eyebolts, eyebolt caps, stand hooks, and stand hook mounting
bolts should be kept in storage with care.
(Never use any other method than
specified to install.)
Werbung
