Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
5. Install the frame.
The display can take an angle of 5, 10, 15 or 20 degrees to the
vertical plane.
Which assembly holes in the columns are to be used depends on
the angle at which the display is to be installed.
1. Place one frame, assembled in the previous page, on each
column, and fasten one end of the frame with one prepared M16
bolt .
2. Identify the hole corresponding to a desired angle, and fasten the
other end of the frame with one prepared M16 bolt .
• The bolt should be securely tightened to the torque given
below.
25~35 N•m
6. Install the joint.
Install the joint onto the left and right frames.
1. As shown in the figure below, align the holes of the joint with those of each frame, and insert M8 bolts (20
mm) from the outside.
2. Put the nuts in from inside the frame, and fasten them with the M8 bolts (20 mm) .
• The bolt should be securely tightened to the torque given below.
12~14 N•m
20
(Inclined hanging)
2
1
Prepared M16 bolt
1
5°
10°
15°
2
20°
2
1
Werbung
