Installation; Wall Mounting - Endress+Hauser EngyCal RH33 Handbuch

EngyCal® RH33
3.3

Installation

The device with field housing, along with the corresponding accessories (see the "Accessories"
chapter in the Operating Instructions on CD-ROM) is suitable for wall mounting, pipe mounting,
panel mounting and installation on the top-hat rail.
The orientation is only determined by the legibility of the display. Connections and outputs are
fed out of the bottom of the device. The pipes are connected via coded clamps.
Operating temperature range:
-20 to 60 °C (-4 to 140 °F)
"
Caution!
To prevent heat build-up, always ensure adequate cooling of the device.
Operating the device in the upper temperature limit range decreases the operating life of the
display.
3.4 Installation

3.4.1 Wall mounting

Use the mounting plate as the template for drilled holes, dimensions → å 4
1.
Fig. 4: Mounting plate for wall mounting
2. Attach the BTU meter to the mounting plate and fasten it in place from the rear using 4
screws.
3. Fasten the mounting plate to the wall using 4 screws.
Endress+Hauser
Installation
a0014169
11