LaserLiner MultiWet-Master Compact Plus Bedienungsanleitung Seite 27

10
Temperature units of measure setting
The units of measure for ambient temperature and material compensation can
be set to either °C or °F. The setting is stored and remains in effect until it is
changed manually.
2 sec
11
Wood moisture/temperature compensation
The relative material moisture of wood is dependent on temperature. The
device automatically compensates for different wood temperatures by
measuring the ambient temperature and using it for the internal calculation.
To increase measuring accuracy, however, the measuring device also offers an
option for setting the temperature manually. This value is not stored and must
be set again each time the device is switched on.
2 sec
12 AutoHold
The AutoHold function is activated as standard and can be deactivated in
the menu. With AutoHold activated, as soon as the measured value is stable
it is automatically held on the display. This status is signalled acoustically.
With AutoHold deactivated, the measured value is continuously updated
on the display.
2 sec
!
Tip: The AutoHold function is suitable for measurements with no
movement. Switch off the AutoHold function for scanning walls.
MultiWet-Master Compact Plus
6x
7x
8x
27
EN