Music Control - Cameo CLMHRGB25W Bedienungsanleitung

oPeRaTion:
STaRTUP
Once you have connected the Cameo LED Moving Head to the power mains,
the motor reset process starts automatically. After approx. 20 seconds, the
motors are realigned and the unit is operational.Focus the projection by
turning the objective ring.
SeLeCTing The dmX STaRT addReSS
Press the MODE button and then use the UP and DOWN buttons to select
the DMX Start Address mode ("Addr" will appear in the display). Now press
ENTER and use the UP and DOWN buttons to select the desired DMX start
address (A001 - A512). Confirm with ENTER.

mUSiC ConTRoL

Press the MODE button ("Addr" will appear in the display) and then use the
UP and DOWN buttons to select the Music Control mode ("SOUN" will appear
in the display). Now press the ENTER button and use the UP button to select
the Master mode (MAST) or DOWN to select the Stand-alone mode (ALON)
and confirm with ENTER. The display will now read "SO-M" for Master mode
or "SO-A" for Stand-alone mode.
In Master mode, additional lights of the same type can be used as slave
units on the master unit. Select the DMX mode for the slave unit and set the
DMX start address to 001. Using a DMX cable, connect the slave unit(s) to
the master unit (master unit DMX OUT - slave-unit DMX IN). Now the slave
unit follows the master unit.
In stand-alone mode, the light operates independently of any other units
connected to it.
miCRoPhone SenSiTiviTY
Press the MODE button ("Addr" will appear in the display) and then use the UP
and DOWN buttons to select the menu item for setting the microphone sensiti-
vity ("MIC" will appear in the display). Press ENTER and use the UP and DOWN
buttons to select the desired sensitivity (M-00 to M-99). Confirm with ENTER.
8