Operating Instructions; Symbols Used; General Safety Notes - Truma Trumatic S 2200 Gebrauchsanweisung Und Einbauanweisung

Trumatic S 2200 / S 2200 P
Table of contents
Symbols used ...................................................................... 12
General safety notes ....................................................... 12
Important operating notes ............................................. 13
Intended use ........................................................................ 13
Operating instructions
Switching on the Trumatic S 2200 P with piezo ignitor ...... 14
Switching on the Trumatic S 2200 with automatic ignitor . 14
Switching off ....................................................................... 14
Servicing ............................................................................ 15
Changing battery on the automatic ignitor ......................... 15
Cleaning (only when the heater is switched off!) ............... 15
Disposal ............................................................................. 15
Technical data ................................................................... 15
Manufacturer's terms of warranty .............................. 15
Installation instructions
Approval .............................................................................. 16
Regulations .......................................................................... 16
Choice of location ............................................................ 16
Exhaust gas and combustion air are routed through the side
wall ...................................................................................... 17
Installation of the heater ..................................................... 17
Exhaust gas and combustion air routing through the
side wall (cowl kit AKW) ................................................ 17
Cowl opening AKW ............................................................. 17
Duct connection to the heater ............................................ 17
Duct connection to the cowls ............................................. 18
Fastening the cowls ............................................................ 18
Exhaust routing via the roof (cowl kit AKD) .................. 18
Assembly of combustion air intake ..................................... 18
Assembly of roof cowl ........................................................ 18
Assembly of exhaust duct ................................................... 19
Fastening the heater ........................................................ 19
Warm air distribution ...................................................... 19
Gas connection ................................................................. 19
Function check ................................................................. 19
Warning information ........................................................... 19
12
Liquid gas heater for caravans and other forms of trailed vehicles

Symbols used

General safety notes

The use of upright gas cylinders from which gas is taken in
the gas phase is mandatory for the operation of gas regula-
tors, gas equipment and gas systems. Gas cylinders from
which gas is taken in the liquid phase (e.g. for fork lifts) must
not be used, since they would result in damage to the gas
system.
If the gas system is leaking or if there is a smell of gas:
- extinguish all open flames
- open windows and door
- close all quick-acting valves and gas cylinders
- do not smoke
- do not activate any electric switches
- ask an expert to inspect the entire system!
A new O-ring must always be installed after dismantling the
exhaust duct!
Guarantee claims, warranty claims and acceptance of liability
will be ruled out in the event of the following:
- modifications to the unit (including accessories),
- modifications to the exhaust duct and the cowl,
- failure to use original Truma parts as replacement parts and
accessories,
- failure to follow the installation and operating instructions.
It also becomes illegal to use the appliance, and in some
countries this even makes it illegal to use the vehicle.
The gas supply's operating pressure (30 mbar) must be the
same as the unit's operating pressure (see type plate).
Liquid gas installations must accord with the technical and
administrative regulations of the individual country in which
they are to be used (e.g. EN 1949 for motor vehicles). National
specifications and regulations in Germany (e.g. the DVGW op-
erational data sheet G 607) must be respected.
The gas installation must be inspected by a qualified
specialist every 2 years, and, if appropriate, this must be
confirmed on the test certificate (in Germany, for example, in
accordance with the DVGW operational data sheet G 607).
The vehicle keeper is responsible for arranging for the
inspection.
Liquid gas equipment must not be used when refuelling, in
multi-storey car parks, in garages or on ferries.
During the initial operation of a brand new appliance (or after
it has not been used for some time), a slight amount of fumes
and smell may be noticed for a short while. This can be rem-
edied by running the heater immediately at maximum output
and ensuring adequate room ventilation.
Symbol indicates a possible hazard.
Risk of burns! Hot surface.
Wear protective gloves to protect against possible
mechanical injuries
Comment including information and tips.
Repairs may only be carried out by an expert.