Troubleshooting - Silvercrest SIKP 2000 B2 Bedienungsanleitung

Troubleshooting

PROBLEM
The appliance does not
function. The control lamp
"Power 4 does not glow.
The appliance does not
start the cooking process.
Shown in the display 8
is E01.
Shown in the display 8
is E02.
Shown in the display 8
is E03.
Shown in the display 8
is E05.
Shown in the display 8
is E06.
Shown in the display 8
is E07.
SIKP 2000 B2
POSSIBLE CAUSE
The plug 2 is not connected.
The appliance is damaged.
There is no cookware on the
cooking area 1.
The cookware is not suitable
for induction cooking areas.
The appliance is not being
supplied with enough voltage
(< 160 V)..
The appliance is being sup-
plied with too much voltage
(> 270 V).
There is a short circuit inside
the appliance!
The appliance is too hot (in
power levels mode)!
The temperature sensor under-
neath the cooking area 1 is
defective or there is a short
circuit..
The appliance is too hot
(in Temperature-Mode)!
POSSIBLE SOLU-
TIONS
Connect the appliance to a
mains power socket.
In this case, contact Custo-
mer Services.
Place suitable cookware
on the cooking area 1.
Use suitable cookware
(see chapter "Suitable
Cookware")
Check and ensure that the
appliance is connected to
a properly installed mains
power socket with
220 - 240 V ~ , 50 Hz.
Check and ensure that the
appliance is connected to
a properly installed mains
power socket with
220 - 240 V ~ , 50 Hz.
Immediately disconnect
the plug 2 from the mains
power socket and contact
the Customer Services
department!
Disconnect the plug 2
from the mains power
socket and wait until the
appliance has cooled
down.
Disconnect the plug 2
from the mains power
socket and contact the Cus-
tomer Services department.
Disconnect the plug 2
from the mains power
socket and wait until the
appliance has cooled
down.
GB
41