Reely W2000 Bedienungsanleitung Seite 9

Step 5: Mount the spinner,propeller and connect the control horns
Fit the propeller to the motor mount and tighten the nut, then install the spinner by tightening the 2
screws. Please be careful of prop orientation. Normally the side with characters faces forward.
Lastly connect all clevis to control horn using the third hole on the control horn. Please adjust the
clevis to make sure the flap, aileron, rudder and elevator should be centered after connection.
Before flying your W-2000 be certain to follow all of the instructions accompanying
your radio control system for charging the transmitter batteries and performing a
range check.
14
Assmbled product as shown below
ADJUSTMENT BEFORE FLIGHT
Section 1:Connect the receiver
2 aileron servos are connected to CH1 with a Y connector,Elevator servo to CH2,ESC
to CH3, Rudder servo to CH4,Flap servo to CH5 or CH6.
Flap Servo
Rudder Servo
ESC
Elevator Servo
Aileron Servo
15