Reely W2000 Bedienungsanleitung Seite 8

ASSEMBLE THE MODEL
Step 1: Mount the motor (Start to assemble Kit version as below)
Mount a proper motor to the motor mount with 4 screws. Guide the motor wires through the
hole under the motor. Connect the motor wires to ESC, and fix the ESC in the cabin.Please
make sure the motor wires don't touch with the motor case when the motor is working.
Step 2: Mount the servos
Install the servo with a piece of 3M tape. And apply some hot glue along the servo outline
to fix the servo securely. Please make sure the servo arm is around 90 degrees to the
pushrod when the servo is powered up and centered.
Open the cover on the fuselage as below to install the servos of elevator and rudder. The
mounting method is same as above. After mounting the servos, please cover it.
12
Step 3: Mount the landing gear (Start to assemble ARF version as below)
Install the landing gear with 2 pcs M3x16 screws to the fuselage. And peel off the tape film,
then attach the yellow cover onto the landing gear. Please fit the cover closely to the outline
of fuselage.
Step 4: Mount the horizontal stabilizer and wing
Slip the horizontal stabilizer in place along the guide rail. Use a M4x35 screw to fix it from the
bottom of tail.
Insert the wing joint tube to the fuselage. Mount the wing halves, and connect the servo wires
of flap and aileron to the connectors on fuselage.
please note that there are labels around the connectors. "A" means aileron. " F" means flap.
Please connect them accordingly.
If it is difficult to insert the wing, you probably need to loosen the fixation screws on the
bottom of wing. After both wing halves are installed, please tighten the screws to fix the wing.
13