Comet SC 147 Anweisungshandbuch Seite 13

2a - high-pressure cleaner KR1100 (fig. 4): fit the end of the extension hose (2) [operation A] on
the quick coupling (4) of the surface cleaner and press to overcome the resistance of the inner
spring; turn clockwise to tighten the connection [operation B].
Fit the end of the spray gun on the other side of the extension hose (2) and press to overcome
the resistance of the inner spring; turn clockwise to tighten the connection [see point 1a]
2b - other high-pressure cleaner models (fig. 5): fit the end of the extension hose (2) [operation
A] on the quick coupling (4) of the surface cleaner and press to overcome the resistance of the
inner spring; turn clockwise to tighten the connection [operation B].
Fit the end of the adapter M22x1.5 (3) [operation C] on the extension hose, press to overcome
the resistance of the inner spring and turn clockwise to tighten the connection [operation D].
Screw the spray gun onto the thread of the adapter (3).
EN
A
B
4
C
A
B
D
5
DETERGENT DISPENSING
Open the cap (6) and fill the tank (8) mixing the detergent liquid with the water in the proportions
indicated by the manufacturer.
The mix must not be too viscous. Regulate the flow by means of the measuring knob (5).
USE
Free the work area of foreign objects and start the cleaning process. The surface cleaner must
always be used flat on the area to be cleaned and must not be used with damaged nozzles. For
better results, drag it over the work area with ample movements.
Be careful when working on uneven surfaces: rough surfaces and loose stone slabs could damage
it. Make sure the rotating nozzles do not touch the ground or protruding objects. Nothing must