Power Control - Telcoma T 200 Installationsanweisungen

GB
FUNCTION SETTINGS (tab. 2)
The control unit is already set with a standard configuration as seen in det. 11 of fig. 1.
Options to the standard operation may be selected by setting the dipswitch functions differently (det. 11 of
fig. 1).
It should be noted that the power supply to the control unit should be cut off and then reconnected
(RESET) before the new settings can be memorised.

POWER CONTROL

The trimmer PW (det. 17 of fig.1) adjusts the motor output power, turn clockwise to increase the power.
PW adjustment is ignored at every start of movement, when full power is applied for a few seconds at the
start and during slowdown.
NOTE:
If the power is regulated too low, the board MAS200, if installed, may activate.
INTERNAL RECEIVER PROGRAMMING
The built-in receiver (one channel) memorises the codes of the TANGO range (TANGO SW, depending on
the version).
To memorise the transmitters, proceed as follows.
- Power the control unit
- Ensure that the dipswitch No.12 (det. 11 of fig. 1) is in the ON position.
- Press the STOP/PROG button (det. 19 of fig. 1) on the control unit; the LED L1 (det. 3 of fig. 1) starts blin-
king.
- Transmit with the remote control to be programmed.
- If the LED L1 produces a longer blink, this indicates the storage has been successful.
- If the code is already stored, the LED L1 blinks fast.
NOTES:
- Code storage may be reset by keeping the STOP/PROG button pressed for approx. ten seconds,
until L1 lights up.
- If this built-in receiver is not used, it MUST be cut out by putting the dipswitch No. 12 to the OFF
position.
SOFT START
The soft-start function ensures that the start of movement is gradual, thereby avoiding jerks to the automa-
tion system. This function may be cut out by inserting a jumper Jp1 (det. 16 of Fig.1).
CAUTION!
Cutting out the soft-start function automatically cuts out motor power control. In this case the
motors should have their own means of control (e.g. mechanical clutch).
59