Telcoma T 200 Installationsanweisungen Seite 56

GB
MOR. MOR.
n. n.
28 25 o 31 N.O. pushbutton
29 25 o 31 N.C. contact
30 25 o 31 N.O. pushbutton
32
33
34 35
Input
* ANTENNA: pay attention if a plug-in radio card is used, since the connector for antenna connection in cer-
tain models is on the actual card.
** If a command is sent with the photocell obscured and gate closed, the control unit does not carry out an
opening movement until the photocell is freed. The command is stored in the T100 for 10 seconds and
the flashing light comes on as a warning.
PROGRAMMING THE WORKING AND PAUSE TIMES
The control unit memorises the working and pause times during programming.
During the learning phase, the key P/P (det. 18 of fig 1) is activated several times, alternatively the control
P/P (terminal 30, fig. 2) or the remote control (if memorised) may be used.
Important checks prior to programming.
- With systems using an electric lock, it should be mounted on the gate leaf driven by motor M1.
- Power the control unit and check correct operation of the control inputs through the relative LEDs (the
LEDs should be on for the NC contacts and off for the NO contacts).
- If the photocell transmitters are powered with the output for the foto-test (term. 14 and 15) check correct
operation by short-circuiting the two "Test" pins (part 13 of fig.1).
- Free the gate area of movement.
- Select one of the types of automation described below to carry out self-learning of the times.
52
DEVICE V
Receiver
antenna Rx*
Receiver
antenna Rx*
Auxiliary
max 24V
Output
I
FUNCTION
max
Pedestrian gate
Stop
Step-by-step
Control unit
Braid
II° Receiver
500mA
channel
NOTES
With 2 motors, opening is carried out
by just motor M1. With 1 motor, ope-
ning is for just 6 seconds.
Stop all functions. Connect this input if
not used to the common terminal.
See functions dip switches No. 1 and
No. 2
For the incorporated receiver, use an anten-
na tuned to 433 MHz. Should a receiver be
connected to the pre-installed connector,
see the antenna characteristics required by
the manufacturer.
Only available if a two-channel radio
card is inserted in the pre-installed con-
nector.