Safety - Wilo -Drain TM 32/7 Einbau- Und Betriebsanleitung

Equipment
Cable type
Cable length [m] / plug
Float switch connected
Whirl device
Non-return device integrated
Pressure support DN: Pipe connection
Hose connection [mm]
Overall height L [mm] (up to connection)
Diameter of pump D [mm]
Level control (fig. 1)
Shaft dimensions
Max. Start-up level
Min. Cut-out level
Min. drainage level
Min. Float level
When ordering spare parts, please give all the information on the pump rating plate.

2. Safety

These instructions contain important information
which must be followed when installing and
operating the pump. These operating instructions
must therefore be read before assembly and
commissioning by the installer and the responsible
operator. Both the general safety instructions in
the "Safety precautions" section and those in
subsequent sections indicated by danger symbols
should be carefully observed.
2.1 Danger symbols used in these operating
instructions
Safety precautions in these operating instructions
which, if not followed, could cause personal injury
are indicated by the symbol:
when warning of electrical voltage with
TM
32/7
H05RNF
3 / earthing
contact
l 35
294
Hmin [mm] 280
Y Bmin [mm]
350 x 350
237
h ± 8 [mm]
h1 ± 8 [mm]
h1 ± 8 [mm]
h2 [mm]
,
TM
32/8
H07RNF
10 /earthing 3 / earthing
contact
x –
– –
– –
– –
l 35
294
–
– 350 x 350
–
50 –
18 18
14 –
The following symbol is used to indicate that by
ignoring the relevant safety instructions, damage
could be caused to the pump/machinery and its
functions:
2.2 Staff training
The personnel installing the pump must have the
appropriate qualifications for this work.
2.3 Risks incurred by failure to comply with the
safety precautions
Failure to comply with the safety precautions could
result in personal injury or damage to the pump or
installation. Failure to comply with the safety
precautions could also invalidate any claim for
damages.
In particular, lack of care may lead to problems
such as:
– Failure of important pump or machinery functions,
– Personal injury due to electrical, mechanical and
bacteriological causes.
2.4 Safety precautions for the operator
Existing regulations for the prevention of accidents
must be followed.
ENGLISH
TMW TMW
32/8 32/11
H05RNF H05RNF
3 / earthing
contact contact
x x
x x
x x
Rp 1 & Rp 1 &
– –
293 323
165
280 330
350 x 350
250 280
50 50
30 30
14 14
ATTENTION!
TMW
32/11 HD
H07RNF
10 /earthing
contact
x
x
x
Rp 1 &
–
323
330
350 x 350
280
50
30
14
11