Version Display - Sony AIT Autoloader Unit TSL-A500C Bedienungsanleitung

Version Display

Auto Load Selection
12
Chapter 2 Operation
When Version is selected in Menu screen, the following screen appears,
where you can confirm the autoloader model, SCSI ID and firmware version.
1
Note the displayed information.
2
Press the EJECT button.
The display returns to the Menu screen.
When Auto Load is selected in the Menu screen, the following screen
appears. From this screen you can select whether the first cartridge
automatically loads when a magazine is placed in the auto loader.
OFF: The cartridges are checked and auto loading does not occur. (This is
the factory default setting.)
Please use this as the usual mode of operation.
ON: The first cartridge automatically loads into the AIT drive after the
cartridges in the magazine have been checked.
1
Press the SELECT button, if necessary, to move the cursor (z) to the
desired setting. You can press the EJECT button to cancel any change to
the selection and return to the Menu screen.
2
Press the ENTER button to accept the selection and return to the Menu
screen.
TSL-A500C
SCSI ID#5
Ver. 0000
S/NL XXXXXXXX
S/ND XXXXXXXX
Version Screen
Auto Load
z OFF
ON
Model Name of this Machine
SCSI ID Number
Firmware Version
Auto Loader Serial Number
AIT Drive Serial Number