Clock Functions - IKEA KULINARISK Handbuch

ENGLISH
3. Push the water drawer to its initial
position.
4. Turn on the oven.
5. Set a steam heating function and the
temperature.
6. If necessary, set the function: Duration
or: End Time
The steam appears after approximately
2 minutes. When the oven reaches the
set temperature, the signal sounds.
When the steam generator is
empty, the signal sounds.
The signal sounds at the end of the cooking
time.
7. Turn off the oven.
Caution! The oven is hot.
There is a risk of burns. Be
careful when you empty the
water tank.
8. After steam cooking steam can
condensate on the bottom of the cavity.
Always dry the bottom of the cavity
when the oven is cool.
Let the oven dry fully with the door open.
When the oven cools down, soak up all
remaining water from the steam generator

Clock functions

Clock functions table
Clock function
Minute
Minder
.
Application
To set a countdown
(max. 2 h 30 min). This
function has no effect on
the operation of the
oven.
Use to turn on the
function. Press or
set the minutes and
to start.
with the sponge. If necessary, clean the
steam generator with some vinegar.
Heat-up indicator
When you turn on a heating function, the
bar on the display comes on. The bar shows
that the temperature increases. When
temperature is reached the buzzer sounds 3
times and the bar flashes and then
disappears.
Fast Heat Up
This function decreases the heat-up time.
Do not put food in the oven when
the Fast heat up function works.
To turn on the function, hold
seconds. The heat-up indicator alternates.
This function is not available for some oven
functions.
Residual heat
When you turn off the oven, the display
shows the residual heat. You can use the
heat to keep the food warm.
Clock function
Duration
End Time
If you set the time for a clock function, the
to
time starts to count down after 5 seconds.
for 3
Application
To set how long the
oven works (max. 23 h
59 min).
To set the switch-off
time for a heating func-
tion (max. 23 h 59 min).
16