IKEA KULINARISK Handbuch Seite 25

ENGLISH
generator. Wait for approximately 10
minutes.
2. Remove the water and vinegar with the
sponge.
3. Put clean water (100 - 200 ml) into the
water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it
dry.
5. Keep the door open to let the appliance
dry fully.
Removing and installing the door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
Warning! The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
A
A
2
B
7. Pull the door trim to the front to remove
it.
8. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the larger
and the door.
One of the hinge-arms (normally
the right one) is free to move.
Make sure, that both hinge-arms
are in the same position
(approximately 70° angle).
Warning! Make sure that the
glasses are inserted in the correct
position otherwise the surface of
the door may overheat.
Replacing the lamp
Put a cloth on the bottom of the interior of
the oven. It prevents damage to the lamp
glass cover and the cavity.
25
1