Installation - Cameo PIXBAR DTW PRO Bedienungsanleitung

SYSTEM INFORMATION (System)
Press the MODE button repeatedly until "Menu" is displayed on the top line of the display. Use the UP and DOWN keys to select the menu
item "System" and press ENTER. Use the UP and DOWN controls to select the desired submenu item, and press ENTER to display the
corresponding information.
System
Firmware = display software version
Temperature = display LED temperature in
degrees Celsius or Fahrenheit
Operation Hours = Displays total operating time
in hours
Menu structure
Menu ENTER
System UP/DOWN

INSTALLATION

Thanks to the rubber feet on the adjustable mounting brackets, the spotlight can be positioned in a suitable location on a level surface.
Traverse installation can be achieved by attaching two suitable traverse clamps (optional) to the
mounting brackets (A). Ensure firm connections and secure the spotlight to the securing lugs (B) with suitable safety cables. Adjust the
beam angle with the side-mounted wing nuts (C).
Important: Overhead mounting requires extensive experience, including the calculation of the load limit values of the installation material
and regular safety inspection of all installation materials and spotlights. If you do not have these qualifications, do not attempt to perform an
installation yourself. Refer instead to a qualified professional.
C
B
A
1U V1.xx
Temperature LED
Temperature
°F/°C
Total
xx:xxh
System
ENTER
Firmware
/
System ENTER
Temp UP/DOWN
/
System
ENTER
OpHours
Press ENTER to display information
= display temperature by pressing ENTER
= select temperature unit to degrees Celsius or
degrees Fahrenheit. Confirm with ENTER
Press ENTER twice to display information
1U V1xx
Temp Temp
/
LED °F/°C
ENTER ENTER - UP/DOWN
Temp Unit
xxx°C
ENTER
OpHours Total
ENTER
Total xxxxh
Unit
/
°C °F
ENTER
C
B
A
11