Connections, Operating And Display Elements; Control Buttons - Cameo PIXBAR DTW PRO Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

4
3
1
POWER IN
Neutrik powerCON power input socket for power supply to the device. A suitable power cable is included.
2 POWER OUT
Neutrik powerCON power output socket for the power supply of additional CAMEO spotlights. Ensure that the total current
consumption of all connected devices does not exceed the value specified on the device in amperes (A).
3
FUSE
Fuse holder. Fuse T2AL/250 V (5 x 20 mm). IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
4
DMX IN
Male 3-pin and 5-pin XLR sockets for connection to a DMX control device (e.g. DMX console).
5
DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal.
6
LC-DISPLAY
Displays currently active mode and the menu items in the Edit menu.
7

CONTROL BUTTONS

MODE – press MODE to access the selection menu for system settings. Press repeatedly to go back to the main display. ENTER – press ENTER
to access the menu levels to make value changes, and to access the submenus. Confirm value changes by pressing ENTER. UP and DOWN –
select individual menu items in the selection menu (system settings, operating mode etc.) and in the submenus. Change a value, such as the
DMX address.
1
7
6
5
2
5