The Best Way To Burn Your Stove; Chimney And Flue - WANDERS Solea Madera Gebrauchsanweisung

gives nice flames and little or no smoke, and the fire
will crackle when burning. Wet wood makes a hissing
sound, gives much smoke and only small flames which
will considerably dampen the pleasure of burning your
stove and the heat output.
Do not put any paraffin-containing logs in your stove.
When the door is closed, the high heat will melt the
paraffin from the logs too quickly. The polluted flue
gasses which consequently develop will deposit on and
burn in the glass of your stove and cannot be removed
later.
Do not use any wood that is painted, impregnated, glued
together or processed in any other way. The flue gases
are very harmful to the environment and may affect your
stove. It is also prohibited to burn plastics and other
waste matter due to poisonous smoke development.
Wood species and storage
You can use all kinds of woods as fuel as long as it
is clean, split and dry. Hardwood like oak, beech
and birch burn slowly, give off much heat and
form charcoal easily. Softer woods like spruce, fir
and poplar give more flames but less heat and less
charcoal.
The best place to store timber is in a windy spot but
sheltered from the rain. This is how the logs can dry
in a natural way. Pile the logs on an old pallet or a
frame to let the wood dry from underneath and to
prevent the lower logs from being in contact with
water.
The best way to burn your stove
All WANDERS' stoves are designed so that they give a
maximum output. A well-lit wood-burning stove can
produce a yield of about 75%. This means that you need
less wood for the same amount of heat. Moreover, a
well-lit stove produces less smoke pollution. Below are
a few tips to give you optimum pleasure:
• For a regular combustion, close the grate shaker when
the stove is fuelled with wood.
• Always burn your stove with its door closed; this
will improve the output within 8 to 0 times. When
the door of the stove is open, the chimney will draw
more air than is needed for proper combustion. The
relatively cold air will cool the fire. It will also preclude
fire damage by any sputtering sparks, especially from
softwood.
• Do not put more than  logs on the fire at one time. Too
much fuel at one time thwarts efficient combustion
and burdens the environment unnecessarily.
• Ventilate the space well when you have the stove on.
A crackling fire has a minimum air consumption of
8
5 cubic metres an hour. Never put on your cooking
hood when you have a stove burning in the same
space.
• Be careful with lighting the stove when it is foggy
or when there is no wind outside. There is hardly
any draught in the cold chimney when the weather
is calm. Since smoke is heavier than air there is the
chance of smoke streaming into the room. In foggy
weather, the smoke from the chimney (outside) cools
quickly and may descend and become a nuisance in
your neighbourhood.
• Don't smother the fire suddenly with water, but let it
burn out. The materials inside the stove may deform
or crack as a result of sudden or great differences in
temperature.
• If you want to temper the fire, first close the valve in
the flue tube and then close the air supply.
Chimney and flue
The chimney is the most important part of your wood-
burning hearth.
When the chimney is right it will not distribute any smoke
into your room, leave any deposit on the glass pane or
create bad combustion. Before starting the installation
of the stove, your installer or a qualified chimney sweep
must check whether the chimney flue has a diameter
of at least 50 millimetres over the entire length, and
whether the channel is clean, smooth and leak-proof.
Chimney with a proper draught
Warm air wants to ascend. This is the principle of
every chimney. It helps when the wind near the
chimney mouth draws the air from the chimney.
Fall wind may give the opposite effect and blow
the air back into the chimney. Relatively cold foggy
air may thwart proper draught in your chimney as
does a long flue pipe with a rough inside and many
bends. If the natural draught in your chimney is poor
your installer can give you information about using
a ventilator for your flue tube.
Maintenance
Small maintenance
• Remove the cooled ash from the ash pan twice or
thrice a week. It is advisable to use an ash bucket. An
empty ash pan is important since the stove also draws
in combustion air via the ash pan.
• It is advisable to leave an ash layer of two to three
centimetres. It will protect the fire plate.
• Clean the shaking grid inside the stove with a soft
brush.
• Clean the exterior of the stove with a damp cloth
that does not give off fluff. Do not use any aggressive
cleansing agents or abrasives.