Operation; Stand Alone-Mode; Sound Control; Automatic - EuroLite LED TWS-20 Bedienungsanleitung

OPERATION

After you connected the spot to the mains, the EUROLITE LED TWS-20 Hybrid Beam Effect starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in Stand Alone via LED display with operating
buttons or alternately in DMX-controlled mode via lighting controller.

- STAND ALONE-MODE



Sound Control



Automatic



Master/Slave

- DMX MODE

STAND ALONE-MODE
Sound Control
Press the MODE button until the LED display shows "snd".
Please press the ENTER button to confirm.
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control. You can adjust the sensitivity with the rotary-control on the rearpanel.
Automatic
In Auto Mode the internal program is called up automatically in a continuous loop.
Press the MODE button until the LED display shows "AUTO".
Please press the ENTER button to confirm.
To set the desired program speed, press the MODE button until the LED display shows "s---". The desired
speed (s001 - s100, increasing) can be selected via the UP or DOWN buttons.
Please press the ENTER button to confirm.
Master/Slave
Set the Master device to Automatic or Sound Control Mode and set each Slave device to the same DMX
address "d001".
DMX MODE
The LED display allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED TWS-20 Hybrid Beam Effect will respond to the controller.
Addressing
Press the MODE button until the display shows one of the DMX modes CH2 or CH8, then press the ENTER
button to confirm.
Set the desired address via the UP or DOWN buttons (d001 - d512).
Please press the ENTER button again to confirm.
Controlling:
After having addressed the LED TWS-20, you may now start operating it via your lighting controller.
21/24 00074881, Version 1.0