Fault And System Messages - WIKA CPH6200-S1 Betriebsanleitung

Hand-Held Pressure Indicator
CPH6200-S1 / CPH6200-S2

6. Fault and system messages

GB
Display Meaning
Low battery power, device will only work
for a short while longer
Battery flat
Mains operation without battery: wrong
voltage
SEnS
No sensor connected
Erro
Connected sensor or device faulty
or Err.9
Value extremely out of measuring range
- - - -
Logger data is being read by the serial
- - - - interface
Battery flat
No display
or strange
Mains operation without battery: wrong
symbols,
voltage or polarity
device is not
System error
responding to
input
Instrument faulty
Err.1
Measured value above allowable range
Sensor faulty
Err.2
Measured value below allowable range
Sensor defective
Err.3
Display range overflow
Err.4
Display range underflow
Err.7
System error
Err.11
Value coul not be calculated
Calculation overflow happened
22 WIKA Operating Instructions Hand-Held Pressure Indicator
Remedy
Replace battery
Replace battery
Check power supply, change it if neces-
sary
Switch off device and connect sensor
If second sensor available, check if
device is ok. Return defective device/
sensor to manufacturer for repair
Check: pressure not within sensor range?
When the data transfer is completed the
device will automatically return to normal
measuring display, no remedy necessary
Replace battery
Check power supply, change it if neces-
sary
Disconnect battery or power supply, wait
a while, re-connect
Return to manufacturer for repair
Check: Is the pressure outside the
sensor's range? -> measured value to
high!
Return to manufacturer for repair
Check: Is the pressure outside the
sensor's range? -> measured value to
low!
Return to manufacturer for repair
Check: value above 9999 -> to high to be
displayed!
Check: value below ‚-2000' (Tare?) ->
to low!
Return to manufacturer for repair
Choose different unit
Choose different unit