Herth+Buss AirGuard Handbuch Seite 81

Operating Instruction
Please start the configuration procedure
again as follows:
Selectyourvehiclewiththecorrectcons-
tructionyear. T riggerallsensorsinorder
toverifywhetherasensorisactuallyins-
talledineachofthetyres(sparewheel!).
SelecttheOBDfunctionforyourvehicle
in the AirGuard.
Connect the AirGuard to the OBD II mo-
dule and then connect the OBD II module
to the vehicle. -> "OBD connected"
Select "Write ID" -> The device will now
commencetheprocess.Ifyouseethe
message"WriteID"onthedisplay,you
can start to trigger the individual wheel
sensorsforconfiguration.
Youonlyrequire1AirGuardtoolto
triggerthesensors. T odothis,youmust
decouple the AirGuard tool from the
OBD II module. The device will indicate
onthescreenwhenyouareallowed
todothis:"Unplugtool..."Proceedby
changing from the OBD function to the
normal sensor diagnosis function in the
AirGuard. Please observe the activation
sequence when triggering:
i. Left front
ii. Right front
iii. Left rear
iv. Right rear
v. Spare wheel
81
After performing the process, please
look to see whether the OBD II module
is lighting a green LED. This means that
everythingisOK.AredLEDmeansthat
an error has occurred when performing
the procedure. Repeat the entire proce-
dure from IMPORTANT onwards.
ReadouttheIDsaftertheconfiguration
procedurehasbeensuccessfullycomple-
tedbyconnectingtheAirGuardtothe
OBD II module again, switching to the
OBD function and selecting "Read ID".
95990001
EN