Data Log For Printer Software "Idtopc; Reading Out And Saving The Data In The Device - Herth+Buss AirGuard Handbuch

Operating Instruction
7.0 Data log for printer software
"IDtoPC"
EN
7.1 Reading out and saving the data in
the device
This function allows you to save up to 20
data records in the device, each with the val-
ues of up to 5 wheel sensors per vehicle, and
then to transfer these to a PC using our "ID
to PC" software.
Up to 20 data records can be stored in the
data log of the device, regardless of whether
just 1 ID or up to 5 IDs of a vehicle are stored
in one data record.
TIP
Savethevaluesinyourcustomerfile
orprintthemoutforyourcustomer.
Number of wheels:
Youcanonlysavesensordatafortheprint
function ID TO PC after setting WHEEL: 4 un-
der Settings in advance. Please first select
the value 4 for the number of wheels in the
settings menu.
www.herthundbuss.com
Please note:
If the wheel value is set to 1 in the
settings, you can perform a normal
sensor diagnosis of a single sensor
on the vehicle. The device however only
retains the value of the last wheel sen-
sor.
Function selection:
Use the arrow buttons to select DIAGNOSE
SENSORandpresstheenterkeyforthedi-
agnosis.
Scanning the ID of the 4 wheels:
The display will show the image of a vehi-
cle with 5 wheels (including spare wheel).
Please use the arrow buttons to select the
respective wheel and diagnose by pressing
theenterkey.
95990001
72