Manually Modifying The Id - Herth+Buss AirGuard Handbuch

Operating Instruction

5.3 Manually modifying the ID

Please note:
The duplication and program-
ming function only works with the
Herth+Buss wheel sensor.
Other sensors cannot be written.
Function selection:
Use the arrow buttons to select MANUAL ID
MODIFYandpresstheenterkeytoselect.
Checking the original ID:
Position the target sensor in parallel with the
AirGuardandpresstheEnterkeytoscanthe
originalIDnumbertoensurethatthisreally
isthetargetsensoryouwishtomodify.
69
Scan complete:
The AirGuard will now show the target sen-
sor ID. You will hear two short beeps after the
sensor has been scanned. Press the enter
keytorecord.
Enter the sensor ID:
Use the arrow buttons to navigate. Press the
enterkeytoentertheIDdigits.
Modification complete:
The AirGuard will now modify the target
sensorforyou. Y ouwillheartwoshortbeeps
afterthesensorhasbeensuccessfullymodi-
fied.
95990001
EN