A UtomaticallyDuplicating An Oe Sensor - Herth+Buss AirGuard Handbuch

Operating Instruction
4.2 Automatically duplicating
an OE sensor
EN
Thisfunctionwasdevelopedtoallowyouto
avoid the teaching process for new sensor
IDs via OBD II.
After selecting the function "AUTO DUPLI-
CATE", it is possible to implement "WIRE
PROGRAMMING" by locking the sensor
in position in the sensor compartment or
"WIRELESS PROGRAMMING" by holding
the sensor in parallel with the device. This
alsoworkswithnotyetactivatedHerth+Buss
wheelsensorsalreadyfittedinthetyre.
Please note:
The duplication and programming
function only works with the
Herth+Buss wheel sensor.
Perform the steps described in 4.1.
www.herthundbuss.com
Function selection:
Use the arrow buttons to select AUTO DU-
PLICATEandpresstheenterkeytoselect.
ID search process:
The AirGuard will now search for the sensor
ID of the OE sensor. The sensor reaction time
may vary according to manufacturer and
sensor type. A successful read-out is con-
firmedwithabeep.
95990001
56