Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting table

Malfunctions can occur in all electrical appliances. This does not necessarily mean
there is a defect in the appliance. For this reason, please check the tables to see if you
can correct the malfunction.
WARNING
Risk of electric shock in case of improper repair!
Never try to repair a defective or suspected defective appliance yourself. You can put
your own and future users' lives in danger. Only authorised specialists are allowed to
carry out this repair work.
Problem
Possible cause
Compressor off,
No electricity to socket.
control unit off.
Mains plug is loose.
Compressor off,
Desired temperature has
control unit on.
been reached.
Appliance cools
Temperature has been set
too quickly.
too low.
T h e
a p p l i a n c e
Temperature has been set
doesn't cool suffi-
too high.
ciently.
Door not tightly closed or
door seal is not completely
tight.
The appliance is near a heat
source or sunlight.
Minimum distances not main-
tained (too short).
Too many bottles of wine
stored.
Ambient temperature too low
or too high.
Compressor seems defec-
tive.
Troubleshooting table
Solutions, tips, explanations
Check the socket with another appliance.
Check the tightness of the mains plug.
Further cooling not required. When the in-
side temperature rises, the compressor au-
tomatically switches on.
Select a higher setting see „Setting the tem-
perature" on page GB-10).
Select a lower setting see „Setting the tem-
perature" on page GB-10).
See "Checking and cleaning the door seals"
on page GB-13.
Place insulation plate between the applianc-
es or change location.
Adhere to the minimum wall distances see
„Choosing a suitable location" on page
GB-15).
Do not exceed the maximum nominal ca-
pacity (see product data sheet at the end of
this user manual).
Adjust the ambient temperature to the cli-
mate category (see product data sheet at
the end of this user manual).
Set the temperature to '4'. If the compressor
does not switch on within an hour, please
contact our service centre (see page GB-23).
Page GB-21

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis