Safety; Intended Use; Explanation Of Symbols; Explanation Of Terms - hanseatic JC-201S Gebrauchsanleitung

Safety

Intended use

This appliance is intended solely for
storing wine.
The wine refrigerator is designed for pri-
vate household use. It is not suitable for
commercial applications or shared use
(e.g. use by several parties in a block of
fl ats).
The appliance is not a built-in device
and is not suitable for insertion into
cabinets, etc.
Use the appliance exclusively as de-
scribed in this user manual. Any other
use is deemed improper and may result
in damage to property or even personal
injury. The manufacturer accepts no li-
ability for damage caused by improper
use.

Explanation of symbols

Warning: Fire hazard!

Explanation of terms

The following symbols can be found in
this user manual.
WARNING
This symbol indicates a hazard with a
medium level of risk which, if not avoid-
ed, could result in death or serious in-
jury.
CAUTION
This symbol indicates a hazard with a
low level of risk which, if not avoided,
could result in minor or moderate injury.
Safety
NOTICE
This symbol warns against possible
damage to property.
This symbol refers to useful addi-
tional information.

Safety notices

In this chapter you will fi nd general
safety notices which you must always
observe for your own protection and
that of third parties. Please also ob-
serve the warning notices in the individ-
ual chapters.
WARNING
Risks in handling household
electrical appliances
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Only use the appliance indoors. Do
■
not use in wet rooms or in the rain.
Do not operate or continue to oper-
■
ate the appliance if
it shows visible signs of damage,
–
e.g. the power cord is defective,
it starts smoking or there is a smell
–
of burning,
it makes unfamiliar noises.
–
In such cases, remove the mains plug
and contact our Service department
(see page GB-23).
The appliance corresponds to protec-
■
tion class I and may only be connect-
ed to a plug with a protective conduc-
tor that has been properly installed.
When connecting, make sure that it
has the right voltage. You can fi nd
Page GB-5