Technical Specifications - Omnitronic MCR-4250 Bedienungsanleitung

Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

11. TECHNICAL SPECIFICATIONS

Power supply:
Power consumption (max.):
Power output sine:
8 Ohm:
4 Ohm:
8 Ohms bridged:
Frequency range:
Damping-factor:
Distortion factor:
Signal to Noise Ratio:
Min. input sensitivity:
Input impedance:
Input:
Output:
Zone outputs:
Control elements:
Protection:
Indicators:
Construction:
Dimensions:
Minimum mounting depth:
Weight:
Please note: Every information is subject to change without prior notice. 12.09.2007 ©
230 V AC, 50 Hz ~
1200 W
4 x 150 W
4 x 225 W
4 x 450 W
20 - 20 000 Hz
>150
0.05 %
95 dB
0.775 V
20 kOhms (balanced), 10 kOhms (unbalanced)
4 balanced XLR-connectors
4 balanced XLR-connectors
4x speaker, 4 x screw connectors
Power switch, Input attenuators (per channel), High pass (per channel),
Matrix (per channel), Volume (per channel), Equalizer (per channel),
Operating mode, Remote
Overheat, overload, short-circuit, DC, softstart, VHF signals
Power, Bridge, Protect, Clip, Signal, Remote
Steel chassis
482 x 490 x 90 mm
19"-dimensions with 2 u
510 mm
25 kg
40/40 00030070.DOC, Version 1.0