Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(9) AC-CONNECTION with FUSEHOLDER
Used to plug the power cord in. Only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse value is specified on the rear panel.
(10)SPEAKER CONNECTIONS
Screw connectors for bridged mode.
(11)SPEAKER CONNECTIONS
Screw connectors for stereo mode.
(12)SPEAKER CONNECTIONS
Speaker output connectors for bridged mode.
(13)SPEAKER CONNECTIONS
Speaker output connectors for stereo mode.
(14)NETWORK CONNECTORS RJ45
Connect these outputs to the remote controls via network cables. The cable length should not exceed
900 m. For remote control R-4, use input ZONE1, only. The remote controls R-1, R-1S and R-2S
can be connected to any RJ45 connector.
(15) HIGH-PASS FILTER ON/OFF
Switches the filter (45 Hz) on and off.
(16) XLR INPUT SOCKET
Connect the input signals here using a balanced XLR-plug.
(17) XLR OUTPUT SOCKET
Connect the output signals here using a balanced XLR-plug.
(18) STEREO/BRIDGE MODE-SWITCH
For selecting the operating mode. In bridge mode, CH1 and CH2 or CH3 and CH4 are combined to
450 W.
(19) ASSIGNING CONTROL [Z1, Z2, Z3, Z4]
Determine the signal level of zones Z1, Z2, Z3 and Z4 distributed to
the respective zone [-80 dB - 0 dB]. Position 0 is OFF
(20) EQ-SECTION
The HI (Treble) control boosts or lowers the upper frequency range of
the respective channel, the MID (Middle) control adjusts the amount of
midrange frequencies and the BASS Control determines the amount of
low frequency boost or cut. The VOL(UME) control sets the signal
level of the respective channel.
29/40
00030070.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
