Operation; Basic Settings; B) Switching Rain Alarm On/Off - Eurochron EFRM 10 Bedienungsanleitung

10. oPeraTIon

a) Basic settings
The basic settings have already been explained extensively in chapter 9. Here, the following
GB
settings can be carried out in sequence:
12/24 hour mode 
hours 
minutes 
year 
sequence day/month or month/day 
month 
day 
rain amount unit mm/inch 
temperature units °C/°F 
rain alarm on/off
Afterwards the setting mode is finished.
In order to call the setting mode, the time or the date has to be shown on the display of
the base station (if necessary press "MODE/RAIN SETTING" (A) button briefly several
times, until you see the time or date).
Afterwards hold the "MODE/RAIN SETTING" (A) button down for several seconds, until
the display mode for the clock ("12h" or "24h") starts to flash on the display.
Adjustment of the values is carried out with the "2SINCE" (B) and/or "8HISTORY"
(C) button and the setting is saved by briefly pressing the "MODE/RAIN SETTING" (A)
button.
If you want to jump a setting, simply press the "MODE/RAIN SETTING" (A) button se-
veral times, without adjusting a value.
The setting mode is automatically left each time you don't press a key for about 10
seconds. The changes carried out so far are each saved.

b) switching rain alarm on/off

Activate the setting mode (see 10. a) and turn the rain alarm on (display on LC display "AL ON")
or off (display "AL OF").
If there is any rain a tone signal is triggered and a rain icon „
the right next to the time/date display). The tone signal sounds for about 2 minutes, it can be
turned off by briefly pressing any key on the front.
The rain icon „
some time (up to 30 minutes).
Afterwards the icon disappears until the next time it rains.
When the rain alarm is switched off there will be no signal.
38
" on the right next to the time/date display will continue to flash for
" will flash on the display (on