Eurochron EFRM 10 Bedienungsanleitung Seite 35

With the "2SINCE" (B) and/or "pHISTORY" (C) button the desired sequence can be selected.
Confirm the setting by briefly pressing the "MODE/RAIN SETTING" (A) button.
–
The month will start to flash.
Adjustment is carried out with the "2SINCE" (B) and/or "8HISTORY" (C) button and the
confirmation by briefly pressing the "MODE/RAIN SETTING" (A) button.
–
The day will start to flash.
Adjustment is carried out with the "2SINCE" (B) and/or "8HISTORY" (C) button and the
confirmation by briefly pressing the "MODE/RAIN SETTING" (A) button.
–
"mm" will flash on the display. Here, the unit of the display of the amount of rain can be
switched between "mm" and "inch".
Adjustment is carried out with the "2SINCE" (B) and/or "8HISTORY" (C) button and the
confirmation by briefly pressing the "MODE/RAIN SETTING" (A) button.
–
"C" will flash on the display. Choose the unit of the temperature display, select between °C
(degrees Celsius) and °F (degrees Fahrenheit).
Adjustment is carried out with the "2SINCE" (B) and/or "8HISTORY" (C) button and the
confirmation by briefly pressing the "MODE/RAIN SETTING" (A) button.
–
And finally the rain alarm can be switched on or off. "AL OF" or "AL ON" flashes on the
display. Switch the rain alarm off ("AL OF") or on ("AL ON") with the "2SINCE" (B) or
"8HISTORY" (C) buttons.
If there is rain a tone signal is triggered (can be deactivated by briefly pressing any key on
the front).
–
After pressing the "MODE/RAIN SETTING" (A) button last, the display of the time (or date)
will appear and the setting mode is completed.
In order to call the setting mode again, the time or the date has to be shown on the dis-
play of the base station (if necessary press "MODE/RAIN SETTING" (A) button several
times, until you see this display).
Afterwards hold the "MODE/RAIN SETTING" (A) button down for several seconds, until
the display mode for the clock ("12h" or "24h") starts to flash on the display.
Now you can carry out the setting as described.
If you want to jump a setting, simply press the "MODE/RAIN SETTING" (A) button se-
veral times, without adjusting a value.
The setting mode is automatically left each time you don't press a key for about 10
seconds. The changes carried out so far are saved.
GB
35