Yamaha RX-V365 Bedienungsanleitung Seite 46

Troubleshooting
After AUTO SETUP
Warning message
PHASE REVERSED
DISTANCE ERROR
LEVEL ERROR
Notes
• If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "AUTO SETUP" again.
• If a warning message "PHASE REVERSED" appears, corrections are made, but they may not be optimal.
• If a warning message "DISTANCE ERROR" or "LEVEL ERROR" appears, no corrections are made.
■
Remote control
Problem
The remote control
does not work nor
function properly.
■
Resetting the system
Use this feature to reset all the parameters of this unit to the initial factory settings. For details about the procedure of
resetting the system, see "Initializing" in "Advanced setup" on page 37.
42
En
Cause
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
The distance between the nearest speaker
and the furthest speaker is out of
adjustable range.
The difference of volume level among
speakers is excessive. (No level correction
is made.)
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Remedy
Check the speaker connections for proper polarity (+
or –).
Bring the speaker closer to the listening position.
If "SWFR:TOO LOUD" or "SWFR:TOO LOW"
appears, adjust the output volume of the subwoofer.
Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
Check the speaker connections.
Use speakers of similar quality.
Remedy
The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
See
page
9
—
16
—
9
—
See
page
8
—
8